which model CRM is it, and do you have stock conrod and piston? i would recommend getting out a set of calipers and measuring the bearing you currently have. inner, outer diameter and width. you can probably get one from LT or just do a search online and source one. Make sure you measure twice befor...

Look out for that Furnuts character... he's ... Nuts

Looks like 2006? CRF250 plastics with the DC Shoe Co Graphics set. (my brand of shoes too!)

thats good looking, i may consider for the MK1... it could use a facelift

i have a non etching acid wash for use with metals.. i just mix a bit with water and run a small electric pump through it. ill let it soak and run the solution through for a half hour or so. this stuff can take the hide off an elephant.

kinda rough on the hands if improperly handled.

the airways are all unblocked and its been cleaned well in and out. i can go a good amount of time in traffic without any overheating problems but its the quick jump between lights which are only 200 yards apart and then sitting for 5 to 10 minutes while all the tourists wander aimlessly in the road...

pull off the headlight assembly, get her running and start wiggling wires.

not a bad idea KK i may do something similar to the front mud guard as on the highway i would swear it was trying to take into flight if i didnt know better.

I have been taking the CRM down to the boardwalk by the local beach and having overheating problems sitting in traffic. i cannibalized one of my junk computers and put a little shroud and 4" fan over 2/3 of the left radiator. didnt want to splice into the wiring harness so i grabbed power off the He...

we rode to work today, it was amazing... the guy at the entry control point of the base had a big grin plastered across his face...

either he liked the crm a whole lot or he was amazed at how i managed to pack a full cubic meter of mud on the frame

(didnt have a chance to wash her last night)

stay away from that furnuts guy... he's looney

we had our first plug foul today...

since i was not going far from home i didnt bring my toolbag.

it was a memorable experience... i pushed her about a mile...

then made the wife come pick me up, got a plug and good to go!

check your breather (just aft of the carb) if its blocked i suppose that could account for some pressure in the case as it gets warm. otherwise, pull out the oil fill plug, if there is pressure building in the case you should be able to feel it (hold your finger over the hole and feel for pressure r...

I've managed to get the MK1 pretty sorted, but when i let off the gas to just cruise at mid throttle, the whole bike chatters, and i get a Popping from exhaust. if i throttle up, it takes off like a bat out of hades and if i keep it at very low revs it runs just fine... but i cant get any mid range ...

just answered my own question...

Bulb type: H6M
Base Type: P15d-25-1

ok, so the bulb is a 12v 30/30w local auto shop didnt have one. or anything like it i searched the web and only found a 2006 yamaha raptor 600 with the same bulb, but couldnt see a picture of it to compare... anyone know of an equivalent or a honda stock number... i dont wanna pay $30 from LT for a ...