Well, i have solved the problem! After opening the servo motor it looks like the grease in there has become caked up the wires were most likely getting caught and dragging. So i cleaned them up, re-greased the cables and wd-40 the mechanism and motor and walah, no problems and went for 200km ride st...

I havn't done the test yet, tomorrow, but in my mind, as its intermittant, it has to be electrical - ie, either the servo motor is becoming catus or the regulator is becoming catus! If was the plastic teeth in the servo it wouldnt work at all and thats the annoying thing, it works fine 90% of the ti...

Hi everyone, i have read the FAQ on this but im still a little lost. Anyway here is a break down of whats been happening - (only 3 times in the last 2mths) Pretty much i will ride the bike, all will be fine. Turn it off, have a coffee. Start it up, go down the road and the powervale won't engage - i...

I've just ordered the 2 bearings for the balance shaft - 1x ball and 1x needle and also the seal and wondering how long it should take to do...is it a hard job or a simple 1-2hr job. I know the cases don't have to be split thank goodness as im looking at the parts diagram but are the bearings hard t...

Anyone got it as a PDF by any chance?

For some reason my turn signal on lamp - next to the high beam lamp has stopped working? I took the bulb out and it is fine along with the wiring? Any quick fixes i don't know about?

Done it...Workedout there is the smallest screw you have ever seen in the trip meter knob you have to get out in order to get the cover off. Clean as a wistle now:)

For some reason i have dust accumulated in the speedo which is bit of a problem when trying to read. I noticed in the parts book at the local Honda dealer that the outside of the cluster comes off or is a separate piece, as i thought it was a sealed unit. How do you get this cover off?

Nathan

Have a CRM AR and for the life of me cant workout where they clip into. Can someone show me:)

Hi Woolley, just checked my inbox...no message?

Looking for a parts diagram for the auto lube setup on a AR...Anyone got it?

Nathan

G'day everyone, im a proud owner of a 1999 CRM250AR. She's in fair condition but its part of the fun in restoring her back to her original self. She's in the shop getting a new bottom end put in, but for now im finding it very hard to find parts, especially mugen parts for it. Could you guys direct ...