Welcome and have fun on the project.

Hi, Can any one tell me what the switch on the clutch lever assy (CRM250/AR) (handlebars) does? one wire is from the turn signal relay for a earth supply I think, this being switched via the clutch lever to ECU what is its purpose? do the other marks of CRM have this as i suspect it could be some th...

Cheers for the info, hex head type now going to be ordered.

Just to add went to replace the front pads and found pin seized, after soaking pin over night, still seized so cut pin in half with a dremel (between the pads i'm replacing any way) then drilled down the center of the pin with small drill bit in dremel this caused the pin to get hot then while still...

Can any one point me in the right direction for a replacement front brake slider pin is there any on E-bay at the moment, not sure which one I require? On the FAQ it states they are 55mm but this is not stated on the E-bay discriptions. Does the CRM250AR 1998 share the same front brake caliper as an...

Hello

Thats another weekend shift working on the removed parts before the frame comes back from paint, just got to remember where they all go LOL.

My name is Daz, Its been a couple of year's since I last owned a bike (Last one was a Gas Gas EC250), So thought it would be a good idea to buy one which needed a little TLC, so managed to buy a 1998 AR from flea bay around the begining of December, she is currently stripped down and frame being pow...