i expect the troodos mountains are are good place to ride off road,the crm dont look that bad

welcome rob i have a crm250 and a KTM 250 exc

hi guys is it ok to fit heated grips to my crm.will the electrical system cope with the extra output.also are the cheap grips off e bay any good does anyone know and does anyone have a wire diagram of where to connect them to if they can be used
cheers

I thought i would take the crm to work today its a 50 mile round trip got to work fine but it was a comedy of errors on the way home firstly the side stand broke off from the frame then it lost its high end power on investigation the power valve cable has broke so where can i get one from or is it a...

i use ATF had no problems

went out on the bike today and my mate came along as he is not mobile at the moment so i lent him my KTM 250 2 smoke we had a great day and the crm ran without fault i let my mate have ago and he said it was like a magic carpet it just does everything so well needless to say he woulnt get off it and...

thanks for the reply it only started to mess about when the water went into the generator it didnt go as far as the carb i know that you are right about the generator but electricity and water never go together so im having trouble getting my head around you saying its ok but being theres no gasket ...

Hi Guys and Girls,well i managed to finally get out on the bike last weekend for a 60 mile ride here in kent the other guys i went with had all quite new machinery gas gas wrs drzs ect and my bike didnt miss a beat only little issue i had was going through deepish water it must have flooded the gene...

hi guys im trying to do the float level on my bike but im a little confused about how to do it correctly i turn the carb over the float totally depresses the needle but i have read that you should adjust the float with the carb at a 45 degree angle so the float is not bottoming out only slight press...

ok thanks for that i had a bit of luck today i went to my mates bike shop and the mechanic said to me that he had an old crm carb somewhere i went back this afternoon and hey presto he found it its got PE31C on it same as mine so im going to do a swap and see if that works and if it does he wants £2...

the plug is an NGK B9EGV Racing plug i cant find any reference to what models this plug fits i will go and buy another plug fuel is new what can you guys recommend for a decent plug
cheers

took the carb off and cleaned it out at work in our ultrasonic cleaner.cleaned all the jets and its still hanging onto the revs so i messed around with the mixture screw and it runs alot better if i screw it out 3/4 of a turn instead of the 1 1/4 turn which it recommends in the manual im going to ch...

the model i have is a mk2.2 the ail filter is new i will check the plug
thanks

Took the carb off today and found that it has been jetted to a 135 main jet and the needle was one notch up from middle (needle lower than standard) it has a dep pipe and silencer should i put it back to standard jetting and needle height as i thought the dep pipe didn't need any jetting mods.the pi...

Thanks guys i will strip the carb off and take a look i forgot to say as well there was like a pinking knocking noise as well it wasnt bad but i could hear it now and again so i guess this points towards a lean mixture