just done it

welcome blazhev theres plenty of parts appear on this site also ebay is the best place
chris

hi tony is the headlamp coming on dim when you use the indicators ? if so then the rear indicators are finding a earth through the tail light & travelling up to the headlamp & then down to earth try connecting a wire to a clean part of the frame & the other end to the earth wire feeding the rear lig...

hi have a right hand side crank case for mk2 if you need it just pay postage, the left hand side has been welded above the gear change shaft & is faulty
thanks chris

my mk2 started running rough didnt respond as quick when reved & i found the groove on the flywheel & the woodruff key both badly worn i fitted a new flywheel & key & problem solved think the previous owner might not have tightened the nut to correct torque hope this helps
chris

hi my old mk2 had the cap off xr650 on it with a rubber breather pipe & i would think any honda that has metal tank should fit
chris

maybe too many wheelies whilst going up hill ? i would re check the level of the gearbox oil maybe there was too much oil in & the steep hills & hard accelaration caused the oil to vent up the breather.it as been known for people to overfill not by much but its very easily done
chris

hi welcome joey nice bike & looks like your having a good time whats the wearher like over there ?
chris

hi kostas i used a 25x47x6 it cost me £4 for both seals from simplybearings.co.uk just fitted new bearings & seals today will see how long they last
thanks chris

thanks skidmark & nkmk1 i will call into simply bearings tomorrow they are just up the road from me
thanks chris

i have searched the what fits what & can only find the sizes for mk1 rear wheel seals which are 25x40x7 x2 .can anyone confirm if the mk1 & mk3 use the same seals
thanks chris

thanks jon i will order 5 then i dont have to keep swapping them when i change to my moto mudguard.i tried david silver website last week but there wasnt a crm listed they bmust be same as xr250!
thanks chris

hi does anyone have the part number for the washer/collar that inserts into the front mudguard where the 4 bolts go through into the bottom yokes?(mk3) or anyone have a spare 1 i have lost 1 while swapping mudguards
thanks chris

i had a brilliant day covered 115 miles was good to meet moose on his mk2 which is like brand new & a shame to get it dirty.ended our day on heartbreak hill & only managed to get 3/4 way up matt managed to get all way up on his crf230.did not get any photos only 1 video of the car wash. hope more cr...

hi mark welcome i am just up the road from you in bolton.theres a good bike shop in atherton b&d motorcycles good stock of c/s & pads etc very helpfull & been there many years enjoy the crm, i am on my second a mk3 & could have swapped it for a 2004 ktm 200sx but the mk3 does everything i want & mor...