Search found 264 matches
- 30 Dec 2014, 08:55
- Forum: Technical
- Topic: temperature and oil level LED wiring colour
- Replies: 5
- Views: 5750
Re: temperature and oil level LED wiring colour
I fitted a Trailtech clock a few years ago but wired the oil level sensor wrong and not bothered to change it, i just use the visual method. One thinhg i did sus out was the temp sender screws directly into the head, saving cutting any pipe work! When i get time i will see if i can get the wiring so...
- 16 Apr 2013, 20:16
- Forum: Technical
- Topic: Coolant from water pump weep hole.
- Replies: 8
- Views: 6706
Re: Coolant from water pump weep hole.
you might find the impeller is on a left hand thread. used to be on the old CR's anyway
Jon
Jon
- 30 Oct 2012, 09:25
- Forum: Technical
- Topic: Exhaust Adaptor
- Replies: 12
- Views: 9048
Re: Exhaust Adaptor
Its a pro circuit! I have got one one mine
- 13 Dec 2011, 23:32
- Forum: Technical
- Topic: Front Fork improvements
- Replies: 27
- Views: 17498
Re: Front Fork improvements
The best improvement i made was fiting the cr250 91 forks, they were cheep and in good condition, but then needed an axle, a caliper mount, new seals. Then machineing the axle to fit the speedo drive. So in a way yes easy to do. I dont know if a new set of spring would have done the same thing, but ...
- 06 Nov 2011, 18:05
- Forum: Technical
- Topic: Mk3 - bike runs but the indicators, lights & horn don't work
- Replies: 7
- Views: 6439
Re: Mk3 - bike runs but the indicators, lights & horn don't work
I'd say the capacitor is disconnected somehow, or has failed. that will loose you the lights or everything really except the engine.
- 13 May 2010, 13:57
- Forum: Technical
- Topic: Main Bearings
- Replies: 9
- Views: 5866
Re: Main Bearings
i was told to replace the mains with C3 so to avoid any heat seizures
- 17 Apr 2010, 21:12
- Forum: Racing / Competition
- Topic: environmental mats
- Replies: 6
- Views: 7816
Re: environmental mats
An enviromental mat is anything that will stop oil or fuel dropping on the ground. if it does that soil MUST be removed, either by you (if your caught) or by the event holders. this is the theory, dont know of anyone actualy being done for it though?
- 17 Apr 2010, 21:08
- Forum: Technical
- Topic: flywheel puller
- Replies: 1
- Views: 2558
Re: flywheel puller
I have one mate, i'm in streatham pm me
- 09 Apr 2010, 21:15
- Forum: Technical
- Topic: sticking fork
- Replies: 4
- Views: 4252
Re: sticking fork
when you tighten the fork clamps, dont over tighten them as that will make the forks stick, also bounce the front end a few time before tightening the axle clamps, this makes sure all is aligned.
- 17 Mar 2010, 19:55
- Forum: Technical
- Topic: Connecion ROD CRM 250 MK3
- Replies: 11
- Views: 7614
Re: Connecion ROD CRM 250 MK3
this should fit the MK3 no prob
- 06 Mar 2010, 22:17
- Forum: Technical
- Topic: Flamin swingarm!!!!!!!
- Replies: 22
- Views: 14114
Re: Flamin swingarm!!!!!!!
you'll find it one of the collars has siezed to the shaft, the cases wont split but you might be better off drilling the ends of the shaft off, or hacksawing the ends off inside then removing the swingarm and engine together, the shaft will then slide out easily. which ever way it will be a lot of w...
- 13 Feb 2010, 19:31
- Forum: Technical
- Topic: Aftermarket Air Filters
- Replies: 11
- Views: 8070
Re: Aftermarket Air Filters
I stick with the xr400 filter, thats what i have always bought
- 12 Feb 2010, 18:35
- Forum: Technical
- Topic: Aftermarket Air Filters
- Replies: 11
- Views: 8070
Re: Aftermarket Air Filters
I believe ther is a K&N filter for the XR400 which is the same
- 29 Jan 2010, 21:04
- Forum: Technical
- Topic: Actual Rim Sizes
- Replies: 7
- Views: 5272
Re: Actual Rim Sizes
sorry just checked and you are correct, I have not rebiult a rear wheel only a front so assumed wrongly that the rear had 36 spokes. I would however check with the supplyer before buying that the rim is suitable.
- 29 Jan 2010, 17:48
- Forum: Technical
- Topic: Actual Rim Sizes
- Replies: 7
- Views: 5272
Re: Actual Rim Sizes
CRM wheels have 36 spokes, look for crm or xr rims from the same sellar he has, a few different styles in the colours you might want or just email him to ask.