On the info page of BA's website they have a very conclusive list of what can and can't be carried. Although it doesn't specifically list pressurized shocks I concluded from the restrictions on gas canisters that they do list that it wouldn't be allowed. Bear in mind that not all luggage holds are p...

not sure what MK you have (maybe put it in your profile or sig) but All Balls do a specific kits for AR's.

Regards
Mark

helisupp wrote:The only gas that you could use is for brazing.

by gas I mean good old oxyacetylene...plain steel frame right?

so just need a delicate hand...I would gas weld it and not risk arc for sure, small reinforcement over it and away you go! (but thats cos I can't TIG) :D quote="helisupp"]I have had several welded so far, the frames are fairly thin walled and TIG is the most delicate way without blowing holes in it ...

No problem getting it TIG welded, do not try any other type of welding on the frame.

why do you say that?

thats great guys - thanks a lot. I thought it did because there are slight rub marks but couldn't remember for sure!

Cheers
SkidMark

Can someone tell me if there are any cables (electrical) routed between the front mudguard and bottom fork yoke? Unfortunately many pictures that I took dont show the one detail I need. Even better if someone can post a picture of the wire routing around the yokes from the front that would be great!...

and which bolt are you removing to check the level?

AR's have a nicosil coating that has to be redone if rebored but I don't think MK3's have that.

take it too your friendly Honda dealer and they should be able to bench check it - they did mine, took about two 5 minutes and didn't charge me anything!

disconnect the cable at the PV pulley, take the exhaust off and set the power valve to full open as view through the exhaust port, mark the arm position at the cable pulley for reference later. refit exhaust, reconnect PV cable to pulley and adjust so that when throttle is full open your mark lines ...

The AR has the best light but if you search around here you will see other lights people have depends. Depends on the cash you want to spend - TrailTech stuff is top notch.

whats the weight difference between the original expansion chamber and the DEP?

Welcome

Is it assembled now or still in bits? either way enjoy the project!

Regards
SkidMark

twistednuts wrote:
It will work better if you take it out of the computer first

bit of drag otherwise - especially if its an 10yr old desktop