hi! last summer i was bought 2 Honda CBR250R 1991 wheels )
very easy to install
front wheel without any changes
rear wheel - i cut off a bottom of elastic bands and have made more deeply cuts under crosspieces , that made its narrow on 8mm
Has changed bearings for installation for native axes

front brake -from kawasaki zzr400
read brake -without changes:)
[IMG]http://s005.radikal.ru/i211/1006/22/445bd69690c1.jpg[/IMG]
[IMG]http://i064.radikal.ru/1006/34/f45426c98cect.jpg[/IMG]

Lower case on the 'IMG'

[img]http://s005.radikal.ru/i211/1006/22/445bd69690c1.jpg[/img]
[img]http://i064.radikal.ru/1006/34/f45426c98cect.jpg[/img]

OK, ^^ didn't work, perhaps someone else can post them up?

You need to be a 'Site Supporter' to post photos directly.

Unusual to have a white Mk1. Looks nice.

http://img404.imageshack.us/img404/3516/crm250r.jpg
http://img16.imageshack.us/img16/763/crm250r2.jpg

Very smart looking moto, even the face on the wall is pleased to see it!

twistednuts wrote:Very smart looking moto, even the face on the wall is pleased to see it!

And the cat
Mike

Does that mean you have to change the caliper if you want to go back to original wheels?


Cheers

Adi

No, its ze same caliper, just on an extension bracket.

Only just noticed the cat

Ooops, just read the start of the thread.

Yeah, guess the caliper would have to be changed

So would it be possible to use original caliper with an extension bracket as you mentioned before?

Cheers

Adi

Dont think the zzr400 caliper would work with crm disc set up, i got mixed up. I thought they were 17" wheels with crm caliper on a bracket.

But yes, you just extend the same caliper to allow for the larger diameter disc