Playmo CRM mk2 motards
Posted: 06 Jan 2014, 10:30
My friend help me to rebuild Mk2 on June 2013....
here are some notes....
When we got this mk2 at first, looks not really well, just can say the engine and wheels can run only ...
but rare to find crm mk2 nowadays, so my friend decide to rebuild it...
But brand new parts are difficult to find, so search many parts online and friends
(cylinder, piston, clutch, 2T pump, rectifier, brushing, seals, gaskets...etc)
1) cleaned the rust and repaint the frame, re-stalled the engine and gear box
(Engine: replaced the second hand cylinder, new piston with rings and lots of seal, rings and gasket)
(Gearbox: cleaned and checked gears, changed new clutch)
(rear damper: changed rings, seals and repainted the spring)
(swing-arm: just cleaned it, bcoz hard to keep it new if I polish it)
http://www.flickr.com/photos/34142038@N03/11792948674/
here are some notes....
When we got this mk2 at first, looks not really well, just can say the engine and wheels can run only ...
but rare to find crm mk2 nowadays, so my friend decide to rebuild it...
But brand new parts are difficult to find, so search many parts online and friends
(cylinder, piston, clutch, 2T pump, rectifier, brushing, seals, gaskets...etc)
1) cleaned the rust and repaint the frame, re-stalled the engine and gear box
(Engine: replaced the second hand cylinder, new piston with rings and lots of seal, rings and gasket)
(Gearbox: cleaned and checked gears, changed new clutch)
(rear damper: changed rings, seals and repainted the spring)
(swing-arm: just cleaned it, bcoz hard to keep it new if I polish it)
http://www.flickr.com/photos/34142038@N03/11792948674/