Hello from new member....
Posted: 23 Jan 2018, 10:52
Hi CMR'ers!
Just wanted to say hi.
I am in the process of rebuilding my CRM AR.
It came to me looking like this....
https://photos.app.goo.gl/VSEURbv4Hd89mWa72
Within 24 hours it looked like this...
https://photos.app.goo.gl/Chriko2yDhyyVqL32
I have had the frame/subframe powder coated, stuck the carb in the ultrasonic bath, restored and re-wrapped the loom, replaced bearings where necessary, sent all original fasteners off for replating and now in the process of rebuilding the forks and shock.
Other than a good clean and spruce up, I've left the engine alone for now as it seemed to run fine.
The re-build, starts soon. I'm sure i will have questions for you all.
Thanks,
Max
PS - apologies for the image links, i could not get GooglePhotos links to preview properly!
Just wanted to say hi.
I am in the process of rebuilding my CRM AR.
It came to me looking like this....
https://photos.app.goo.gl/VSEURbv4Hd89mWa72
Within 24 hours it looked like this...
https://photos.app.goo.gl/Chriko2yDhyyVqL32
I have had the frame/subframe powder coated, stuck the carb in the ultrasonic bath, restored and re-wrapped the loom, replaced bearings where necessary, sent all original fasteners off for replating and now in the process of rebuilding the forks and shock.
Other than a good clean and spruce up, I've left the engine alone for now as it seemed to run fine.
The re-build, starts soon. I'm sure i will have questions for you all.
Thanks,
Max
PS - apologies for the image links, i could not get GooglePhotos links to preview properly!