coolant bleed
Posted: 05 Mar 2017, 19:44
Hello I'm hoping someone can advise me on the coolant bleeding procedure , I have recently rebuilt a mkII crm I acquired, I topped up the radiator and opened the bleed bolt on the water pump until the coolant started to run out... thereafter closed the radiator cap and tightened the bleeder bolt but after about 8 minutes of idling the temp light came on , I immediately shut the engine off ,I'm not certain if the thermostat is opening or if the bike needs to be moving forward to ensure the temp light stays off but either way I'm afraid to do any damage until I'm certain I've followed the correct filling and bleeding procedure , I'd appreciate any advice regarding this.
P.S. I did look through the FAQ before posting my question without any luck
P.S. I did look through the FAQ before posting my question without any luck