Hi Everyone,
I took the PV cables out of my MK3 to clean and grease them, went for a cup of tea and then couldn't remember which side they go back in on the PV servo - Doh! I have attached the cable with the locknut on the left of the PV arm to the left hand side of the PV servo, is this correct?

Cheers.

There is a very informative section in this forum under the general name "FAQ - Check here first".

I believe this topic of the above section will help...

Yeah, I checked here first. As the diagram says, it's a general view for illustration purposes, not an accurate diagram. My PV servo is on the opposite side of the barrel to the diagram, therefore the cable posistions in the diagram may not be correct for my MK3 - although they probably are.

All powervalves and PV servos turn the same way so you can work out from the diagram which cable goes where for whatever position you put the servo in.

well as far as i can see on my mk2 the adjuster cable goes to the front of the engine hope that helps mate