Fitting new graphics?
- ugly1171
- New kid on the block
- Reactions:
- Posts: 20
- Joined: 07 Jul 2003, 22:23
- Location: Peterborough
Fitting new graphics?
Got a new set of decals for my CRM which now want fitting. What's the best way of fitting them without making a ballsup of it? Been told to Tcut the panel(s), spray a mist of water on the panel (to help slide the decal into position) then force the water out with a rubber edged spatular.
Anyone tried this or is there a better way?
Ugly
Anyone tried this or is there a better way?
Ugly
- oldboyoncrm
- New kid on the block
- Reactions:
- Posts: 6
- Joined: 10 Feb 2005, 11:11
hot air
Once you have em in position and stuck use a hair dryer to warm both them and the plastics up, use a soft cloth to press them into position working from the centre out (small circular motion works best) DONT let em get too hot !, once you have done this they will stay attached even if you jet wash.