Page 1 of 1
hot exhaust and plastics ?
Posted: 13 Mar 2011, 22:20
by back off road
after doing the CR 125 conversion ive found the edge of the side panel is touching the silencer
ive seen two products to hopefully stop the panel melting
http://cgi.ebay.co.uk/ws/eBayISAPI.dll? ... 1334wt_905
http://cgi.ebay.co.uk/10M-EXHAUST-MANIF ... 2413wt_994
has anyone used either of these products or can recommend another solution that doesnt involve pipe bending ?
Re: hot exhaust and plastics ?
Posted: 13 Mar 2011, 22:26
by back off road
Re: hot exhaust and plastics ?
Posted: 14 Mar 2011, 17:00
by SkidMark
small strip of aluminium tape on the panel?
Re: hot exhaust and plastics ?
Posted: 15 Mar 2011, 23:30
by back off road
whats the best thing to attatch it with ?
Re: hot exhaust and plastics ?
Posted: 16 Mar 2011, 17:57
by SkidMark
attach what with...?
Re: hot exhaust and plastics ?
Posted: 16 Mar 2011, 18:33
by twistednuts
Liquid nails or araldite?
Re: hot exhaust and plastics ?
Posted: 16 Mar 2011, 19:35
by abigsupermoto
the exhaust end can shouln't get too hot anyway on a two stroke, you can get aluminium foil in strips from a plumbing/gas supplier if you really want to use it and it is self adheasive (like sticky tape just peel of the backing)
Re: hot exhaust and plastics ?
Posted: 16 Mar 2011, 20:47
by back off road
sorry skid i didnt read your reply properly missed the tape bit out
Re: hot exhaust and plastics ?
Posted: 17 Mar 2011, 14:08
by SkidMark