Crankshaft Seals

[Furnuts]

i am pretty sure i read it here before but i couldnt locate the thread so here goes...

the crankshaft seals, little (mag) side is 22 x34 x7 ? is this correct?

and the big (clutch) side, is 36 x52 x8 ? is this correct?

i used a set of calipers to get this off what was left of my seals...

i was about to put the case halves together earlier when i hear this "crunch" "Crunch" "CRUNCH"
im like WTF Mate?

and after a few laps around the yard i finally managed to wrestle my bag of seals away form the stupid dog...

ill probably just get them at the local honda dealer or at a bearing supply shop if i can verify the size of them.

fur.

[knackeredMk1]

Little one - 22x43x7 91203KAE003
Big one - two versions 38x52x9 91202KAE003 & 38x52x8 91202KAE004

[Furnuts]

i think youve transposed some numbers on the little seal,

little seal 22 x 34 x 7

and on closer inspection, the big seal looks to be correct at 38 x 52 x 8 or 9, thickness isn't a concern

hopefully the local bearing shop has these

[knackeredMk1]

Oops . You are correct.

[Furnuts]

c.. could you repeat that?

[Active Rascal]

Can anyone confirm this for the CRM AR:

91202-KAE-731 Crankshaft seal (large- clutch side)??
91203-KAE-003 Crankshaft seal (small- mag side)

Cheers.

[knackeredMk1]

Correct.

[Active Rascal]

The top (large one) is different to the one you listed. I have one here, and just want to confirm this, knocking a parts list up, which I will post on here when eventually complete.

Shaun.

[knackeredMk1]

Because these are listings for a Mk1 almost 2 years ago and the 2 above are no longer made.

Yours is for a Mk3/AR which I think has replaced the ones for the Mk1 now.

[Active Rascal]

OK mate, thanks! :)