I'm making a kit so i can blow out the dents in my header pipe.
What i would like to know is what sort of air pressure do i need to maintain in the exhaust while i heat it up?
Also will a butain gas blow tourch (plumbers type) be hot enought?
many Thanks

in my kit it says no more than 40 psi and make sure the inside is thoroughly clean, you dont want it gong off bang when your heating it. Jon

I've got dents in my fuel tank

Do you think I should empty the tank before trying the same ?



















KABOOOM

if you try can you post a vid of your efforts...............

I had a dent in my head, used 35psi and shoved a carrott in my left ear.

Now my helmit dont fit no-more.

Lucky you didn't put the carrot up your ar**, or it would have blow your helmet clean off

LMAO

A good way to remove 'pop' dents in the tank is the good old toilet plunger. By poking the handle end of a screwdriver inside the tank and pumping on the plunger I removed a muther of a dent in 2 minutes.