Jetting time

oneandonly04 · Post by **oneandonly04** » 23 Jul 2007, 11:03

on wednesday i'm going to replace my reeds with the boyesen 633's and clean out the ol' carb on my AR, but it's written in the little booklet that came with the reeds that i should change the pilot and main jets by a few sizes. Is it possible to go to my local Honda shop and he'll have on hand the jets that i need? also what sizes are the standard jets?

Post by **Gwyn** » 23 Jul 2007, 11:36

[b]oneandonly04 :[/b]
> on wednesday i'm going to replace my reeds with the boyesen 633's and clean
> out the ol' carb on my AR, but it's written in the little booklet that came
> with the reeds that i should change the pilot and main jets by a few sizes.
> Is it possible to go to my local Honda shop and he'll have on hand the jets
> that i need? also what sizes are the standard jets?

This is what ive done to my mk2, with a full RSV pipe, and Aktive reeds, which i think are similar to Boyesens............................

PILOT JET-50----(48 IS STANDARD).
MAIN JET-135----(128 IS STANDARD).

Hope this helps

oneandonly04 · Post by **oneandonly04** » 23 Jul 2007, 11:57

Thanks gwyn. A bit of searching in the modifications part of the site says the stock jets for a AR are:
slow jet 48
main jet 148

so did you just go to your local honda dealer and they had the jets on hand, or did you need to order them in?

Post by **Gwyn** » 23 Jul 2007, 12:58

[b]oneandonly04 :[/b]
> Thanks gwyn. A bit of searching in the modifications part of the site says
> the stock jets for a AR are:
> slow jet 48
> main jet 148
>
>
> so did you just go to your local honda dealer and they had the jets on hand,
> or did you need to order them in?

I ordered them from Leisure trail in the UK.

http://www.leisuretrail.co.uk/

Post by **Jonorow** » 23 Jul 2007, 16:58

yuor honda dealer should be able to sort you out with jets, just tell them its a PE series Carb and poss take the old ones with youto match them. Jon

Jetting time

Jetting time

Re: Jetting time