Okay, so fixed my end can, repacked with fresh packing, joined it all together and it sounds great but a bit blowy, especially around where the two pipes meet. I haven't used any exhaust putty stuff because i don't know if i should. What do you guys do? and also it's a bit blowy around where the alloy oval pipe is hexy bolted on? should i seal it around there too? ta, RD>

Hi RD what you need is a tube of RTV sealant 'this is a high temp silicone type sealant.Wynn's do a brilliant one thats in a pressurised cannister' it last for years and is always thier when you need it 'just read instructions first ***** p/s thats not kisses that's the 5 star rating id give it

good luck

Mike

[quote="fallenmikethebike"]Hi RD what you need is a tube of RTV sealant 'this is a high temp silicone type sealant.Wynn's do a brilliant one thats in a pressurised cannister' it last for years and is always thier when you need it 'just read instructions first ***** p/s thats not kisses that's the 5 star rating id give it

good luck

Mike[/quote]

Cheers Mike, i'll get some!! RD.

fallenmikethebike wrote: 'just read instructions first ***** p/s thats not kisses that's the 5 star rating id give it
Mike

Dont worry Mike, there's a lot of it about at the moment