hi can someone tell me the float height setting for an AR as looked on other pages got info for mark 1 ,2 and 3 16mm but then see a post that said 16mm for all crm,s except ar so just wondering if anyone can clarify many thanks.

huggy wrote:hi can someone tell me the float height setting for an AR as looked on other pages got info for mark 1 ,2 and 3 16mm but then see a post that said 16mm for all crm,s except ar so just wondering if anyone can clarify many thanks.

USE SEARCH FACILITY (yes I know I'm shouting...)

hint: its on second page of results if you search for 'AR float height' or the first page if you search for 'AR carb Specs'



Kindest Regards

SkidMark

[quote="huggy"]hi can someone tell me the float height setting for an AR as looked on other pages got info for mark 1 ,2 and 3 16mm but then see a post that said 16mm for all crm,s except ar so just wondering if anyone can clarify many thanks.[/quote] thanks for the info seems to be noting in concerete there either and the spec sheet only has mark 1,2 and 3 stuff on it . so i will try the blooming 16 mm and kep my fingers crossed hey!

The real AR standard carb specs...

Main Jet is 148
Pilot Jet is 48
Needle is fixed (no clip to adjust)
Air Screw 1 3/4 turns out
Float Height 16mm