Hi all
Just about to replace the wheel bearings and seals on my CRM and noticed that the 2 spacers on the back and the 1 on the front are badly worn.
are these spacer still available?

Also the nylon gear for the speedo drive is worn, can this be bought on it's own or would i have to buy the whole assembly.


Oh! and one more thing! when i took the nylon gear out there was a steel ring, looks a bit like a cir-clip with the ends missing! is this right?

Any help would be much appreciated.

Cheers
Mark

I am finding a few speedo drive parts in USA on ebay very cheap, I have just purchased an XR400 speedo drive in as new condition for £6 and £4 postage, not a bad buy.