seems I didnt take very good photo's of this area..

attempting to put it back together a few times now.

but is something wrong? - before I put the arm with the wheel on the end in / I could select gears by spinning the drum.



is this crazy off?

of course the arm from the actual shaft ( that goes thru to the actual foot) isnt on - but thats straight forward...

any one got a photo please?

well put the gear lever on.. and I can change gear.. but the gear lever isnt manually returning to center postion,,

so either I am missing a spring -

or the spring in there aint doing its job?

Have you got the little springs and 'bullet like' caps in position?

think so! that was fun getting all that in.

seems like i only got 3 gears now.. maybe gonna split the case again cos it might have sliipped when i cracked it yeaterday for the snapped bolt,



oh well practice makes perfect

Shouldn't that little wheel with the spring on be inside the selector bit? I'm sure it sits on those little shapes inside.

yep it does, took the whole thing apart an put it back together again, only maybe a bit differently cos now its workign

nex drama- where the hell did that balance shaft key go??

is there an easy replacement for it? its only a little metal bar?