Hello,
I've got a pair of 1992 cr 125 forks which i plan to fit to my Mk3.

The forks will fit in the yokes but i can see that i will need to change the spindle/axle to suit and also that the brake caliper bolt holes are in a very different position.

Can anyone tell me how to get a front caliper fitted in the correct position?

If i get a compatible spindle will that be likely to fit the standard crm bearings?

thanks

you will need the caliper bracket as well pal

You may also need to change any mix of spindle, bearings, spacers as well, particularly if the original CR spindle is bigger than 17mm.

speedodrive might be a issue as well. with my cr 125 91 forks i had to make a spacer/cover for this when trail tech was set up. can't remember if standard forks had a groove for it to sit in

thanks very much fellahs, a bit more fiddling to do ....