Indicator dont work
- maciej_mi
- Regular Visitor
- Reactions:
- Posts: 115
- Joined: 12 Aug 2009, 11:20
- Bike Owned: MK3
- Location: POLAND
Indicator dont work
In my crm front indicator haven got voltage, bulb is ok, ground of wires also, which one cube response about front position light and flashing, i clean all wires by electrical cleaner and still don' works.
-
- NWAA Supporter
- Reactions:
- Posts: 39
- Joined: 22 Jul 2014, 20:23
- Bike Owned: 1991 MK2
- Location: Pordenone, Italy
Re: Indicator dont work
Maybe a bad ground? It happened to me
- maciej_mi
- Regular Visitor
- Reactions:
- Posts: 115
- Joined: 12 Aug 2009, 11:20
- Bike Owned: MK3
- Location: POLAND
Re: Indicator dont work
Ground is ok, i try this ground to another light, it was ok.
- Speeddevice
- Visitor
- Reactions:
- Posts: 68
- Joined: 28 May 2015, 06:56
- Bike Owned: Mk 2
- Location: Sydney, Australia
- Contact:
Re: Indicator dont work
The flasher relay is a small round or square block up near the headlight, about 25 x 25mm. It has a connector with two pins that can easily be unplugged and changed.
Also check the indicator switch as the contacts in there can get dirty or worn.
Have you got a copy of the wiring diagram for testing?
Also check the indicator switch as the contacts in there can get dirty or worn.
Have you got a copy of the wiring diagram for testing?
- maciej_mi
- Regular Visitor
- Reactions:
- Posts: 115
- Joined: 12 Aug 2009, 11:20
- Bike Owned: MK3
- Location: POLAND
Re: Indicator dont work
I have checked a black little electronic box responsible for running lights (and flashers), and diagnose was 0 Volt on positive pole directly on box, i clean everything and no results so i borrow positive pole from rear flasher to have a turn signal (without running light )