AR using too much oil

Post Reply
User avatar
mike hurtley
New kid on the block
New kid on the block
Reactions:
Posts: 3
Joined: 23 May 2006, 22:33
AR using too much oil

Post by mike hurtley » 10 Jul 2006, 14:37

I have bought an AR which was converted to premix. I have now changed it back to a pumped system although to save money found a second hand oil pump from a mark 2 which according to LT has same gearing. The thing is that if the pump is set to mark it uses a massive amount of oil, far more than a mark 2. On a short ride using 4 ltrs of fuel I had used 100 ml of 2 st oil whereas a mark2 on same ride only used 40 ml of oil. The bike is also a pig to start and only runs well when the throttle is open wide. Is this amount of oil usage right for an AR or do I need to look at sourcing the right pump?

User avatar
edarter
Visitor
Visitor
Reactions:
Posts: 97
Joined: 19 Aug 2003, 13:46
Location: Oxon

Post by edarter » 13 Jul 2006, 13:09

I've got no idea what the oil consumption should be but are you sure the pump is definately off a Mk 2 ?? If LT say it's the same then I would say they are right. Poor starting etc would suggest something is not right carburation wise which may be contributing, but may not be. I suppose if you get an AR pump then you know it must be right and can start to fault find from there...

User avatar
mikey11000
New kid on the block
New kid on the block
Reactions:
Posts: 46
Joined: 01 Apr 2006, 23:10
Location: cumbria

Post by mikey11000 » 13 Jul 2006, 14:40

how does the bike run on premix? if its ok then would sugest oil is fouling the plug at low revs. hence running ok at full revs.the reason there run on premix is for better performance for racing.i would check the cable ,make sure it opens and shuts properly .what cable are you using?not sure if theres a difference between mk2 and ar.failing that sounds like a duff pump. keep us posted

User avatar
mikey11000
New kid on the block
New kid on the block
Reactions:
Posts: 46
Joined: 01 Apr 2006, 23:10
Location: cumbria

Post by mikey11000 » 13 Jul 2006, 14:49

just had a look at the honda manual and it says reason for using to much oil is faulty pump or can be poor quality oil.hope this helps

User avatar
mike hurtley
New kid on the block
New kid on the block
Reactions:
Posts: 3
Joined: 23 May 2006, 22:33

Post by mike hurtley » 16 Jul 2006, 12:06

Have ordered the correct pump from leisure trail. AR is supposed to use considerably less oil than mk 2. Let you all know results

User avatar
Andy R
New kid on the block
New kid on the block
Reactions:
Posts: 4
Joined: 06 Mar 2004, 14:26
Location: Nottingham

Post by Andy R » 26 Jul 2006, 01:15

When I called in to Leisure Trail the other week they said that the AR pump was different to the other models (looked in he parts book).

How much is a new pump for the AR?

Andy

User avatar
mike hurtley
New kid on the block
New kid on the block
Reactions:
Posts: 3
Joined: 23 May 2006, 22:33

Post by mike hurtley » 26 Jul 2006, 11:09

The pump cost £95. The bike is using less oil now but I have not been on a decent ride yet to work out how much.


Post Reply