Float Height on a CRM MK2

Post Reply
User avatar
Nails
New kid on the block
New kid on the block
Reactions:
Posts: 9
Joined: 18 Feb 2006, 10:25
Float Height on a CRM MK2

Post by Nails » 26 Jul 2006, 21:39

How do you adjust it?
Top
User avatar
CRM'er
New kid on the block
New kid on the block
Reactions:
Posts: 37
Joined: 28 Jul 2003, 10:57
Location: New Zealand

Post by CRM'er » 27 Jul 2006, 20:53

Adjust it by bending the metal tab that pushes on the float needle, bend it closer to needle to lower the float height bent it away from needle to raise float height.
Top
User avatar
edarter
Visitor
Visitor
Reactions:
Posts: 97
Joined: 19 Aug 2003, 13:46
Location: Oxon

Post by edarter » 31 Jul 2006, 12:08

presumably this is while holding it with the carb in the horizontal position, not on it's side ?
Top
Post Reply

Return to “Technical”