Mk 2 Suspension ideas

santidreamer · Post by **santidreamer** » 10 May 2008, 05:01

The rear suspension has a inner tube air valve on the under side of the reservoir cylinder.

What pressure range is recommended/ are people setting their bikes to?

Post by **NaBz** » 10 May 2008, 07:10

im fitting yz ones to mine not a strait fit tho bottom yoke need to be bored slightly

Post by **knackeredMk1** » 10 May 2008, 10:36

The 'air valve' takes very high pressure nitrogen. In the order of 200psi I think - not an item you should mess around with if you don't know what you are doing.

santidreamer · Post by **santidreamer** » 13 May 2008, 13:36

The MK 3 suspension is better than the MK 2, are any of the bits from the forks interchangeable?

Given that either YZ or CR springs either fit are a direct fit or can be made to fit, what can be done about the damping?

How much of an effect would using thicker oil make?

Would any of this actually help or simply make the suspension harder and less comfortable?

Mk 2 Suspension ideas

Re: Mk 2 Suspension ideas

Re: Mk 2 Suspension ideas

Re: Mk 2 Suspension ideas

Re: Mk 2 Suspension ideas