Hi -

Splund · Post by **Splund** » 25 May 2008, 15:58

Just a quick West Sussex hello to all here.
Hopefully I will be getting my first CRM250 tomorrow,
Its a Mk3, thats all I know about it at the moment.
Always been a trialy/enduro/crosser rider.
Apart from the usual checks, Is there anything in
particular I should be looking for?
It has been used for laning but he assures me its
been regularly serviced and well maintained.

Many thanks
Bob

Post by **fallenmikethebike** » 25 May 2008, 18:09

Hi splund and welcome.
Wheel bearings require more attention than most bikes.
Apart from that ,yes its all the normal caveats, is it his, to sell? does it go , in all the gears,? does it stop ?, any ominous expensive sounding noises? it is a TRAIL bike you want right?
regards Mike

Post by **Gwyn** » 25 May 2008, 19:29

Hi Splund and welcome 8)

Think Mike has covered it 8)

Splund · Post by **Splund** » 25 May 2008, 20:26

OK thanks for that, I dont know much about the bike, until tomorrow,
but I will check the wheel bearings for sure.
They do seem to get a good write up on the net.
I will post pics if I get it, im that excited I will probably
buy it anyway

Bob

slider · Post by **slider** » 26 May 2008, 08:11

ayup bob and welcome to the forum.as mike says wheel bearings also swingarm,shock+ linkage and headstock bearings then the usual bike checks.good trail bikes these crm's

Hi

Hi

Re: Hi

Re: Hi

Re: Hi

Re: Hi