Power/No power...

Post Reply
User avatar
njhardy
Forum Regular
Forum Regular
Reactions:
Posts: 204
Joined: 07 Sep 2011, 10:27
Bike Owned: CRM250 Mk3
Location: Vietnam
Power/No power...

Post by njhardy » 07 Nov 2012, 06:01

So here's the thing- 1st, 2nd, 3rd, 4th gear fine- loads of power all the way through to the red line. From 5th onwards, she just bogs down from 1/4 throttle onwards... I have had the carb apart more times than hot dinners- new jets and tang heights set... Plug is chocolate brown on a plug chop, so I don't think its a carb problem.... Could this be an ECU issue??

User avatar
fishtail
Site Supporter
Site Supporter
Reactions:
Posts: 1048
Joined: 13 Jan 2012, 11:29
Bike Owned: CRM 250 Mk3
Location: derby/leicester border.
Re: Power/No power...

Post by fishtail » 07 Nov 2012, 10:07

its true that the ECU does know what gear you are in.. actually there a wire for each pair of gears - going from near the gear selector around the back of the flywheel.. I think I saw it in the manual too.. are all those wires ok?

you dont think it could be compression related?
1996 CRM 250 "Mk 3" FMF pipe .... - the other 'un is a 98 hornet 600 - Sai Kung Hong Kong

User avatar
njhardy
Forum Regular
Forum Regular
Reactions:
Posts: 204
Joined: 07 Sep 2011, 10:27
Bike Owned: CRM250 Mk3
Location: Vietnam
Re: Power/No power...

Post by njhardy » 08 Nov 2012, 06:16

Not sure Mart- I have tried a few things. I will disassemble and check the gear selector wires and the ECU connector this weekend. I will also go back to starnard jetting and see what happens. Can't be compression- I have just rebored...


Post Reply