Indicator dont work

[maciej_mi]

In my crm front indicator haven got voltage, bulb is ok, ground of wires also, which one cube response about front position light and flashing, i clean all wires by electrical cleaner and still don' works.

[ameadows7]

Maybe a bad ground? It happened to me

[maciej_mi]

Ground is ok, i try this ground to another light, it was ok.

[Speeddevice]

The flasher relay is a small round or square block up near the headlight, about 25 x 25mm. It has a connector with two pins that can easily be unplugged and changed.

Also check the indicator switch as the contacts in there can get dirty or worn.

Have you got a copy of the wiring diagram for testing?

[maciej_mi]

I have checked a black little electronic box responsible for running lights (and flashers), and diagnose was 0 Volt on positive pole directly on box, i clean everything and no results so i borrow positive pole from rear flasher to have a turn signal (without running light )