well i made a start on rebuilding crm, started polishing swingarm.
used w+d then started polishing with cutting wheel on bench grinder, ran out of course cutting paste.
now to hinder the build even more the wind has taken all me fences down
started to remove posts today and found masses of concrete so gonna hire a jake hammer monday ( i booked hols mon-tue-wed for repair work).
then to top it all found a gas pipe running lenght of fence so gotta be careful
I wish i was polishing me swingarm

i know were your comin from mate iv been out with a hammer and a bag of nails today good luck with your rebuild (both of em!) polishing the swingarm it sounds like your goin for it

i will post pics of polished swingarm........ crm needs a few jobs doin'
money jobs: rechrome fork tubes.....powdercoat frame. the rest is mainly labour polishing.
coulnt get fence panels today sold out!!!! so long as i get posts in while im off thats the donkey work done........