just brought a mk2 crm250, bit of a heep,but i plan to keep it and restore it, it is a bugger to start but i think that maybe the piolet jet, where is the best place to buy spares. i need a speedo,ignition switch,switch gear,chain guard,new piolet jet
i would like some new plastics, does anyone do them or are cr250 ones the same?
i will post some photos when i get round to it.
Paul

hi raz....

most of your answers can be found here.....
viewforum.php?f=20
some very helpful lads an lassies on the forum and many diverse and wonderful rebuilds and make overs of all mk's ....d

side panels are the problem ,if you can get them they cost a fortune over £140 for the pair when i looked into replacing mine ,so i went down the cr route and replaced pretty much everything ,subframe(modified) seat ,tank ,airbox & plastics for less than the price of the panels but spent a few hours in the garage making it all fit. Good luck theres plenty of help on here

Read the relevent articles in - viewforum.php?f=20 before you make big mistakes (CRM125 parts for eg ).

can the rear shock be rebuilt? wheres the best place for discs/pads?

rear shock is rebuildable and discs pads are readily available i favour ebc not the cheapest but very good whatever the conditions

A good place to get parts from is leisure trail Iv got loads of stuff of em

its a good idea to get a price comparison against leisuretrails prices as at times they are on the expensive side of reasonable imo

got it going, new plug and pilot jet, runs pefect, front forks ok, back shock buggered, rear brake buggered, easy to ride with lots of low end power