Page 1 of 1
CRM250 MKII rebuild data needed
Posted: 02 Jan 2015, 22:24
by bally123
Hi Just about to inspect this motor for a friend. Does anyone have the recommended piston to bore clearances and crank inspection data?
Cheers Andy
Re: CRM250 MKII rebuild data needed
Posted: 05 Jan 2015, 13:16
by nicko
I reckon piston/bore clearance is 0.07mm
Re: CRM250 MKII rebuild data needed
Posted: 05 Jan 2015, 17:22
by knackeredMk1
The data should be the same as an AR. In which case there is a full maintenance manual in the download section of the FAQs ............