ar float height settings

huggy · Post by **huggy** » 20 Oct 2009, 21:04

hi can someone tell me the float height setting for an AR as looked on other pages got info for mark 1 ,2 and 3 16mm but then see a post that said 16mm for all crm,s except ar so just wondering if anyone can clarify many thanks.

Post by **SkidMark** » 21 Oct 2009, 04:47

huggy wrote:hi can someone tell me the float height setting for an AR as looked on other pages got info for mark 1 ,2 and 3 16mm but then see a post that said 16mm for all crm,s except ar so just wondering if anyone can clarify many thanks.

USE SEARCH FACILITY (yes I know I'm shouting...)

hint: its on second page of results if you search for 'AR float height' or the first page if you search for 'AR carb Specs'

Kindest Regards

SkidMark

huggy · Post by **huggy** » 21 Oct 2009, 16:04

[quote="huggy"]hi can someone tell me the float height setting for an AR as looked on other pages got info for mark 1 ,2 and 3 16mm but then see a post that said 16mm for all crm,s except ar so just wondering if anyone can clarify many thanks.[/quote] thanks for the info seems to be noting in concerete there either and the spec sheet only has mark 1,2 and 3 stuff on it . so i will try the blooming 16 mm and kep my fingers crossed hey!

AlanH · Post by **AlanH** » 21 Oct 2009, 21:47

The real AR standard carb specs...

Main Jet is 148
Pilot Jet is 48
Needle is fixed (no clip to adjust)
Air Screw 1 3/4 turns out
Float Height 16mm

ar float height settings

ar float height settings

Re: ar float height settings

Re: ar float height settings

Re: ar float height settings