Hello from new member....

maxhouse · Post by **maxhouse** » 23 Jan 2018, 10:52

Hi CMR'ers!

Just wanted to say hi.

I am in the process of rebuilding my CRM AR.

It came to me looking like this....
https://photos.app.goo.gl/VSEURbv4Hd89mWa72

Within 24 hours it looked like this...
https://photos.app.goo.gl/Chriko2yDhyyVqL32

I have had the frame/subframe powder coated, stuck the carb in the ultrasonic bath, restored and re-wrapped the loom, replaced bearings where necessary, sent all original fasteners off for replating and now in the process of rebuilding the forks and shock.

Other than a good clean and spruce up, I've left the engine alone for now as it seemed to run fine.

The re-build, starts soon. I'm sure i will have questions for you all.

Thanks,
Max

PS - apologies for the image links, i could not get GooglePhotos links to preview properly!

rc46 · Post by **rc46** » 23 Jan 2018, 11:28

Nice, wellcome

Post by **gregorious77** » 23 Jan 2018, 22:16

good luck and enjoy

Gammakeith · Post by **Gammakeith** » 24 Jan 2018, 16:07

Welcome! MY AR is patiently waiting its turn for the same treatment

My frame is certainly rustier than yours!

Keith

Hello from new member....

Hello from new member....

Re: Hello from new member....

Re: Hello from new member....

Re: Hello from new member....