Rev Counter!?

CRM'er · Post by **CRM'er** » 27 Sep 2005, 06:43

Is it possibe to fit a rev counter to the crm? I'll be getting rid of the old speedo and fitting a digital one so will have room for a small rev counter. Just onedering if it is possible to hook up to anything to get the reading.
Cheers

lee_p · Post by **lee_p** » 27 Sep 2005, 08:19

Most coils are permant live with a switched earth, so you should be able to get a pulse from the coil. CRM works on wasted spark like most two strokes so you may need to read one pulse and then ignore next pulse(wasted spark) otherwise 1300rpm will show as 2600rpm.

Lee

edarter · Post by **edarter** » 27 Sep 2005, 12:45

what Speedo are you looking at using ? sounds like a nice way of modernising the clocks !

THE FLUTE · Post by **THE FLUTE** » 27 Sep 2005, 15:01

Try this works on 2 stroke not sure about uk stockist though But if we could get a few of us together we could split the postage
http://tinytach.com/tinytach/commercial.php

CRM'er · Post by **CRM'er** » 28 Sep 2005, 09:57

I was thinking more like an analog rev counter, something good for road use. There are a number of digital speedo's out there, even a mountain bike one would be good(as long as it can read over 99km/h). But there are some really good looking trail speedo's out there that are expencive but would do the job great!

Post by **admin** » 28 Sep 2005, 18:29

i have one of these fitted to my rgv250SP
http://www.veypor.co.uk

[/img]

edarter · Post by **edarter** » 29 Sep 2005, 12:23

very nice - but £200 !!! ouch !

lee_p · Post by **lee_p** » 29 Sep 2005, 13:02

Admin has far tooooooooooo much money and bikes, you would think he would share them out been as hes such a nice guy

(so I've been told) especially as hes on my door step.

Lee