input shaft bearing

Post by **pudzie83** » 04 Dec 2015, 15:15

Hi all im trying to source a input shaft bearing for my mk2 (the one with seals located behind the clutch basket) leisure trail have none left has anyone got any information on where else might have them?

or has anyone got one kicking around they never used??

thanks

Post by **fallenmikethebike** » 04 Dec 2015, 19:46

Have you tried a bearing factor outlet?
Mike

jompy · Post by **jompy** » 04 Dec 2015, 20:19

+1 Mike
Take the bearing to a bearing suppliers

Post by **pudzie83** » 05 Dec 2015, 14:46

Im going to pop to the local bearing place monday if i get no luck on here got every other one but that

jompy · Post by **jompy** » 05 Dec 2015, 16:34

I'm sure if they don't have it they'll order it

Post by **pudzie83** » 06 Dec 2015, 00:15

discontinued jompy il get one made if need be

jompy · Post by **jompy** » 06 Dec 2015, 12:04

sorry bud i meant if the bearing factors don't have it they'll order it in for you

Post by **knackeredMk1** » 06 Dec 2015, 12:19

On the parts diagram it is very difficult to be sure what bearing goes where but if you can give me the outside diameter and perhaps the inside as well then I can work out which one it is. It is very likely that it is a standard size anyway.

Post by **pudzie83** » 07 Dec 2015, 13:26

The measurements are 56 outside 24 inside and 15 whith bearing number is sco5a86 and the seal on one side has the same code but ending in lu

My mechanics doing some digging around so hopefully we get somewhere and a search on google has brought some leads up to chase

Post by **pudzie83** » 10 Dec 2015, 16:50

well people it looks like ive sourced the "obsolete" bearing! defeat is just a word

i will be ordering and if all is good i will post the link as it may help others

Post by **knackeredMk1** » 10 Dec 2015, 17:51

Yes but it's 24x56x14.

Honda part no, 91001-ML3-873 Not sure why there is a CRM part no for this? Perhaps there is a different number if bearing seals or none?
Suzuki p.n. 09262-24001

~£11.

Post by **pudzie83** » 10 Dec 2015, 18:11

would one of those 91001-ML3-873 bearings be ok? il be honest im not very clued up when it comes to bottom ends

Post by **knackeredMk1** » 10 Dec 2015, 18:31

According to all the sizes this will be fine.

Post by **pudzie83** » 10 Dec 2015, 18:42

thanks knackered

do you know if it will have a seal? the original bearing has a seal on one side is this important?

Post by **knackeredMk1** » 10 Dec 2015, 18:56

If the bearing comes with two seals then take the one off that isn't on the original. If there are none don't worry.

input shaft bearing

input shaft bearing

Re: input shaft bearing

Re: input shaft bearing

Re: input shaft bearing

Re: input shaft bearing

Re: input shaft bearing

Re: input shaft bearing

Re: input shaft bearing

Re: input shaft bearing

Re: input shaft bearing

Re: input shaft bearing

Re: input shaft bearing

Re: input shaft bearing

Re: input shaft bearing

Re: input shaft bearing